Shock Assembly (Walker Evans) - Polaris GENERAL 2016 Service Manual

Table of Contents

12. Replace all seal case o-rings and seals. Then, grease

before reassembly. Torque nut to specification.

Piston Lock Nut: 36 lb-ft (49 Nm)

13. Take apart the two halves of the body. It should

separate into three separate pieces.

Use a heat gun to aid in disassembly.

14. Remove the base valve.

15. Remove the IFP from reservoir eyelet cap.

9929375 R02 - 2016-2019 GENERAL / GENERAL 4 Service Manual

STEERING / SUSPENSION

16. Replace all o-rings.

SHOCK ASSEMBLY (WALKER EVANS)

1. With the needle in the charge port, push IFP until it

bottoms out. Then, remove the needle.

2. Replace o-ring in the coupler thread on body side.

Thread onto the main body with threadlocker.

3. Install the base valve into the can. Then, install the

second o-ring into the coupler.

Table of Contents