Polaris GENERAL 2016 Service Manual page 335

3. Install rear bearing carrier and mounting fasteners
Torque fasteners to specification.
TORQUE
Rear Bearing Carrier Mounting Fasteners:
42 lb-ft (57 Nm)
4. Apply Anti-Seize to drive shaft axle splines.
5. Install rear wheel hub assembly
washer domed side out
castle nut.
NOTICE
2016–2017 models have two cone washers.
9929375 R02 - 2016-2019 GENERAL / GENERAL 4 Service Manual
© Copyright Polaris Industries Inc.
q
.
w
. Install the cone
e
and hand tighten the
6. Install rear brake caliper assembly and NEW
mounting bolts. Torque to specification.
TORQUE
Rear Caliper Mounting Bolts:
46 lb-ft (62 Nm)
CAUTION
New bolts have a pre-applied locking agent which is
destroyed upon removal. Always use new brake caliper
mounting bolts upon assembly.
r
7. Torque wheel hub nut to specification and install a
t
NEW cotter pin . Tighten nut slightly if necessary to
align cotter pin holes. Bend both ends of cotter pin
around end of spindle in different directions.
TORQUE
Wheel Hub Castle Nut:
180 lb-ft (244 Nm)
8. Install wheel and wheel nuts.
TORQUE
Wheel Nuts (Steel):
60 lb-ft (81 Nm)
Wheel Nuts (Alum):
120 lb-ft (163 Nm)
NOTICE
Do not lubricate the stud or the lug nut.
9. Rotate wheel and check for smooth operation.
FINAL DRIVE
7
7.33