Polaris GENERAL 2016 Service Manual page 356

Table of Contents

9. Install armature plate. Be sure all of the armature

plate tabs are fully engaged into the roll cage

assembly and that it is resting properly on the torsion

spring retainer.

Verify armature plate tabs are in the roll cage slots and

that it rests properly on the spring retainer.

10. Carefully install the ring gear and roll cage assembly

into the gearcase housing.

11. Install a new O-ring on the cover plate assembly.

Be sure the square O-ring is placed flat on the cover

surface. If the O-ring is twisted fluid leakage may occur.

12. Carefully install the LH output hub assembly into the

cover plate. Take care not to damage the new cover

plate seal while installing the output hub.

13. Install the output cover assembly onto the gearcase

housing. Install the seven cover plate screws and

torque to specification.

Cover Plate Screws:

9 ft-lbs (12 Nm)

9929375 R02 - 2016-2019 GENERAL / GENERAL 4 Service Manual

Chapters

Table of Contents