Power Steering Unit Installation - Polaris RZR 570 2013 Service Manual

POWER STEERING UNIT INSTALLATION

1. If the power steering unit was removed from the
mount bracket, reinstall it prior to vehicle installation.
Torque the mounting bolts to specification.
2. Remove the throttle pedal return spring to ease
power steering unit installation.
3. Install the power steering unit into the vehicle and
align the skip-tooth spline on the power steering stub
shaft with the opening in the lower steering shaft.
4. Place power steering mount bracket over the brake
pedal mount studs and finger tighten the four nuts.
5. Position the lower steering shaft on the power
steering unit stub shaft and install the pinch bolt.
Torque to specification.
TORQUE
Lower Steering Shaft Pinch Bolt:
36 ft-lb (48 Nm)
9926813 R04 - 2013-2016 RZR 570 Service Manual
© Copyright Polaris Industries Inc.
STEERING / SUSPENSION
6. Torque the four mount bracket nuts to specification.
TORQUE
Power Steering Unit Mount Bracket Nuts:
16 ft-lbs (22 Nm)
7. Reinstall the throttle pedal return spring.
8. Proceed to Upper Steering Shaft Installation (EPS
Models), page 8.12 to complete the installation
procedure.
8
8.11