Balance Shaft Removal / Inspection - Polaris GENERAL 2016 Service Manual

ENGINE / COOLING SYSTEM
14. Remove the eleven M6
crankcase bolts.
15. Rotate the engine so the cylinder is facing down.
16. Remove the eight M10
lower crankcase bolts. Discard the eight M10 bolts.
17. Tap on the lower crankcase in reinforced areas with
a soft faced hammer to loosen. Carefully lift up and
remove the lower crankcase half.
3.50
g h
and two M8 upper
k l
, two M8 and one M6

BALANCE SHAFT REMOVAL / INSPECTION

1. Perform Crankcase Disassembly / Inspectionpage
3.48 procedure.
2. Note timing marks on balance shaft and crankshaft
drive gears. Shafts must be properly timed upon
assembly.
j
3. Carefully rotate the balance shaft
from the crankcase.
4. Inspect the balance shaft gear teeth for damage.
9929375 R02 - 2016-2019 GENERAL / GENERAL 4 Service Manual
w
and remove it
© Copyright Polaris Industries Inc.