Power Steering Unit Installation; Upper Steering Shaft Installation - Polaris RZR XP Turbo Service Manual

STEERING / SUSPENSION

POWER STEERING UNIT INSTALLATION

1. If the power steering unit
w
mount bracket , reinstall it prior to vehicle
installation. Torque the mounting bolts
specification.
TORQUE
Power Steering Mounting Bolts:
30 ft-lb (41 Nm)
2. Install the power steering unit into the vehicle and
align the skip-tooth spline on the power steering stub
shaft with the opening in the lower steering shaft.
3. Place the power steering mount bracket over the top
of the brake pedal mount studs and finger tighten the
four nuts.
4. Position the lower steering shaft on the power
steering unit stub shaft and install new fasteners.
Torque to specification.
TORQUE
Steering Shaft to EPS Unit Pinch Bolt:
25 ft-lb (34 Nm)
8.8
q
was removed from the
e
5. Torque the four
specification.
to
Power Steering Unit Mount Bracket Nuts:
6. Proceed to Upper Steering Shaft Installation, page
8.8.
7. Vehicles equipped with Dynamix suspension having a
steering shaft, EPS unit, steering rack, or tie rod
removed/adjusted/disconnected MUST have Steering
Angle Sensor Centering procedure performed once
everything is reinstalled. Refer to Steering Angle
Sensor Centering (Dynamix), page 11.31.

UPPER STEERING SHAFT INSTALLATION

If steering wheel was removed, follow this procedure to
ensure the upper steering shaft is properly positioned
on the power steering stub shaft.
Striking the steering wheel or steering shaft while
installed in the vehicle can permanently damage the
EPS unit and cause a Power Steering Fault.
Be sure upper steering shaft hardware is positioned
9928491 R04 - 2017-2018 RZR XP Turbo / XP4 Turbo Service Manual
mount bracket nuts
TORQUE
16 ft-lb (22 Nm)
NOTE
CAUTION
NOTE
correctly.
© Copyright Polaris Industries Inc.
y
to