Polaris GENERAL 2016 Service Manual page 324

Table of Contents

6. Install the front propshaft and align with the alignment

mark on the rear propshaft.

Paint marks are applied to the front and rear prop shafts

to aid shaft alignment. Reference these marks during

installation if still visible.

7. Ensure proper orientation of the support bearing

assembly. The shallow ridge of the bearing should be

facing upwards.

8. Align the front prop shaft paint mark with the front

gearcase input shaft mark so the pin holes align.

Install a new roll pin.

Always use a new roll pin when installing the front

propshaft onto the gearcase. Do not reuse roll pins.

9. Torque the support bearing fasteners to specification.

Support Bearing Fasteners:

33 lb-ft (45 Nm)

10. Install the skid plates on the vehicle. Refer to "Skid

Plate Replacement"page 10.73 procedure.

9929375 R02 - 2016-2019 GENERAL / GENERAL 4 Service Manual

Chapters

Table of Contents