Polaris GENERAL 2016 Service Manual page 111

CRANKSHAFT PTO SEAL INSTALLATION
w
1. Install new seal into crankcase. Thread the drive
bolt of special tool PU-52493
IMPORTANT
The orientation of the seal is critical. Install the seal with
the flat side of the seal facing out as shown.
9929375 R02 - 2016-2019 GENERAL / GENERAL 4 Service Manual
© Copyright Polaris Industries Inc.
2. Tighten the drive bolt
q
into the crankshaft.
3. Once the seal is properly installed, loosen the drive
4. Refer to Inner PVT Cover installation.
5. Field test the vehicle before putting back into service.
ENGINE / COOLING SYSTEM
e
until the cylinder
out against the crankcase.
e
bolt and remove special tool PU-52493 from the
crankshaft.
Inspect for any leaks.
r
bottoms
3
3.25