Polaris GENERAL 2016 Service Manual page 157

21. Apply a thin, continuous film of Crankcase Sealant
(PN 2871557) to sump cover mating surface
shown. Do not allow sealant to dry before assembly.
h
22. Install the oil sump cover
j
23. Install the thirteen M6
k
retain the oil sump cover
9929375 R02 - 2016-2019 GENERAL / GENERAL 4 Service Manual
© Copyright Polaris Industries Inc.
24. Torque the oil sump cover bolts in sequence to
g
as
onto the crankcase.
25. Install the crankcase drain plug if previously
26. Install the oil cooler
and three M8 bolts that
to the crankcase.
27. Proceed to Flywheel Installationpage 3.72 and then
ENGINE / COOLING SYSTEM
specification. Repeat the sequence to verify final
torque.
TORQUE
Oil Sump Cover Bolts:
M8 Bolts: 26 ft-lb (35 Nm)
M6 Bolts: 106 in-lb (12 Nm)
removed. Torque drain plug to specification.
TORQUE
Crankcase Drain Plug:
12 ft-lbs (16 Nm)
l
. Use new O-rings
installation. Torque fasteners to specification
TORQUE
Oil Cooler bolts:
7 ft-lbs (10 Nm)
Cylinder Head Installationpage 3.75.
3
1 (
upon
3.71