Table of Contents
Advertisement
Checking before Installation
Following shows requirements for the installation site. Therefore, it is desirable to see the installation site in advance before
bringing in this equipment to the user's site.
Checking Power Supply
1. The host machine can singly connect to the outlet of rated +/-10V, 15A or more.
2. Install the Host Machine near the power outlet and leave sufficient space around the power plug so that it can be unplugged
easily in an emergency.
Checking the Installation Environment
1. The installation site must be in the following environment. Especially, avoid installing the machine near the faucet, water
boiler, humidifier, or refrigerator.
Operating environment: Temperature: 10.0 to 30.0oC Humidity: 20 to 80%
2. Avoid installing the machine near fire, in an area subject to dust or ammonia gas. When installing the machine in a place
exposed to direct rays of the sun, it is recommended that curtains be hung over the windows.
3. The amount of ozone generated during use of the machine is below the harmful level. However, if the machine is used for
a long time in a poor-ventilated room, ozone may smell. To keep the work environment comfortable, the room must be well-
ventilated properly.
4. None of the machine feet should float. The machine must be held level constantly.
5. The machine must be installed at least 10 cm away from the surrounding walls and there must be an adequate space for
operating the machine.
Checking Installation Space
The space required for installation and maintenance work is shown below.
Points to Make Before Installation
Be sure to go through the following before starting the work.
1. Imaging faults can result due to dew condensation that occurs when the machine is moved from a cold place to a warm
place. Leave the unpacked machine as it is for at least two hours before installing it.
(Dew condensation: When a metallic object is brought from a low-temperature place to a high-temperature place, water vapor
around it is cooled abruptly and consequently water drops stick to the surface of the metallic object.)
2. The maximum weight of the machine is approx. 78.8 kg (double-cassette model supplied with a DADF). Accordingly, two or
more persons are required to lift the machine. Be sure to with a DADF). Accordingly, two or more persons are required to lift
the machine. Be sure to keep the machine in a horizontal position when lifting it.
3. This product was designed considering the potential connection to the Norwegian IT power distribution system.
100mm or more
500mm
or more
1341mm
565mm
500mm
1372mm
or more
307
500mm
or more
9. Installation
Advertisement
Table of Contents
Troubleshooting
