Installing The Software Tools - Thermo Scientific Accela Open Autosampler Hardware Manual

Installing the Software Tools

Thermo Scientific
This section describes the procedure to install the software tools for the column switch option.
 To install the software tools
1. Install the PAL Loader as described in
page 156. Make sure to use PAL Loader version 2.1.0 or later.
2. Install the Object Manager as described in
Make sure to use Object Manager 2.2.1.
Note The PAL Loader and Object Manager are included on the Accela Open
Autosampler Controls software CD that comes with your Accela Open Autosampler.
Note If Xcalibur 2.1 or later is installed, remove "Accela Open AS" from the
Configured Devices list in the Instrument Configuration window
Figure 105. Thermo Foundation Instrument Configuration window
"Installation of PAL Loader Software"
"Installing PAL Object Manager"
Accela Open Autosampler Hardware Manual
D
Column Switching Option
Installing the Software Tools
on
on page 180.
(Figure 105).
191