Unpacking The Components - Thermo Scientific Accela Open Autosampler Hardware Manual

2
Installing the Accela Open Autosampler
Installing the Autosampler and DLW

Unpacking the Components

12 Accela Open Autosampler Hardware Manual
An Accela Open Autosampler system is shipped in three boxes. The contents of these boxes
are as follows:
Box 1: Contains the x-, y-axes assembly, the injection unit, keypad terminal, stand-alone
supports, connecting cables, power supply, syringe kit, wash station assembly, safety guard,
and miscellaneous parts. See
Box 2: Contains the DLW injection kit.
Box 3: Contains the cooled stack and the Accela Open Autosampler table.
 To unpack the components
1. Open Box 1 and first remove the accessory boxes and the injection unit before attempting
to remove the x-, y-axes assembly.
2. Carefully lift the x-, y-axes assembly and remove it from the box. Hold the y axis in place
while you are removing the assembly from the box. Set the x-, y-axes assembly on a bench.
3. Unpack the remaining small boxes and any other accessories.
4. When placing the Open Autosampler onto a stable surface, make sure that no objects
interfere with either the y axis or the injection unit throughout the entire range of
potential movement.
The Accela Open Autosampler Dynamic Load and Wash (DLW) option ships in one box
(Box 2). Check for the following items:
1. DLW Pump Module
2. DLW Syringe Needle
3. DLW Syringe
4. DLW Plunger Holder
5. DLW Flow Diverter (installed in DLW Syringe assembly)
6. DLW Syringe Holder assembly
7. CD-ROM
8. Wash station cable to PAL System
9. DLW Tubing Kit
10. DLW Holding Loop (installed in DLW Syringe assembly)
11. Needle guide length tool
12. DLW Wash Station incl. waste tube
"Open Autosampler Components" on page 1.
Thermo Scientific