Thermo Scientific Accela Open Autosampler Hardware Manual page 204

C
PAL Object Manager
Getting Started with PAL Object Manager
186 Accela Open Autosampler Hardware Manual
In the example using the LC syringe, 25 μL, the Object Manager software might send
two objects in a single file. In this case, the first object contains the geometric definition
of the syringe itself and the second object specifies which plunger motor driver is assigned
to this particular syringe.
The same concept is used to send the desired objects to the Accela Open Autosampler for
all other object lists.
The Object Manager always lists the object being sent in the last line of the PAL firmware
class, visible from the local terminal. The Object Manager software can quickly check
whether the PAL firmware has received the new object.
In some cases—seen in particular in the PAL but not in the PAL-xt System—you might
receive an error message: Memory full. To resolve this problem, you must delete as many
objects as possible from the Accela Open Autosampler that you are not using. You can
link a syringe to a method and a job. First delete the job, then the method, and finally the
syringe object. See "To delete objects"
objects.
Confirm your understanding of the Object List parameters and descriptions to make sure
that the correct, desired objects are sent to the PAL firmware. In certain cases where
complexity is greater—for example, multi-position valve drives—the guideline provides
the correct order of steps in the process to provide reliable functioning of the Accela Open
Autosampler.
 To delete objects
Use the Accela Open Autosampler handheld device to delete objects.
In the handheld device, objects are displayed as a tree. Identify the object and delete it
according to instructions in
To delete multi-object items, delete the lowest items first and then remove higher objects
until you delete the top-level object.
on page 186 for information about deleting
"Operating the Accela Open Autosampler" on page 55.
Thermo Scientific