Setting Up The Chromatography Software; Installing The Software And License - Thermo Scientific Dionex ICS-4000 Installation Instructions Manual

Setting Up the Chromatography Software

Installing the Software and License

Thermo Scientific
To connect using an external hub, connect the USB cable to the hub and connect the hub
to the computer. For installation details, refer to the manual provided by the hub vendor.
Figure 21. Example USB connections: System connected to an external hub
Other USB Device
Other USB Device
B
3. If you are installing an autosampler, locate the USB cable supplied with the autosampler.
Connect the cable between the USB connector on the autosampler and either a USB port
on the Dionex ICS-4000 or the external hub.
IMPORTANT Carefully secure all USB cables, the external hub (if used), and the hub
power cable so that they cannot be accidentally disconnected.
Note You can set up the software now or wait until later in the installation procedure. The
hardware installation procedure can be completed using the Dionex ICS-4000 front panel
touch screen only.
Software setup consists of installing Chromeleon software and the software license on the
computer (if they are not already installed) and starting the Chromeleon 7 Instrument
Controller Service or Chromeleon 6.8 Server Configuration Program.
To install Chromeleon software and the software license if they were not installed at the
factory, follow the instructions in the appropriate installation guide. The guides are provided
on the Thermo Scientific Reference Library DVD (P/N 053891).
• For Chromeleon 7, refer to Chromeleon 7 Installation Guide.
• For Chromeleon 6.8, refer to Installing Chromeleon with a Dionex Ion Chromatograph
(Document No. 031883).
Autosampler
B B
USB Cables
A A
USB 2.0 Hub
Setting Up the Chromatography Software
Dionex
ICS-4000
B
PC
A A
B
A
Dionex ICS-4000 Installation Instructions
2
System Setup
15