Thermo Scientific Accela Open Autosampler Hardware Manual page 35

Thermo Scientific
 To install the x axis on the cool stack
1. Loosen the two Torx™ screws on the three mounting clamps (2 located on top of the stack
and 1 on top of the autosampler leg).
Figure 7. A microplate stack with three drawers
2. Carefully lift the x-axis assembly on top of the stack with the mounting clamp teeth
fitting into the grooves on the bottom of the x axis.
3. Ensure the clamps fit completely into the grooves. Alternately tighten the three Torx
screws until the three mounting clamps are firmly in place.
4. Ensure the stack clamps are correctly attached to the x axis
aligned attachment of the x axis to both the cool stack and autosampler leg.
Figure 8. Attachment of stack clamps
2
Installing the Accela Open Autosampler
Installing the Autosampler and DLW
Figure 7 shows the stack model with 3 drawers.
(Figure
Accela Open Autosampler Hardware Manual
8). Also ensure the
17