Thermo Scientific Accela Open Autosampler Hardware Manual page 143

Thermo Scientific
Table 42. Objects in the Extended User mode
Object
Injectors
Valves
Agitators
Dilutors
Tools
Positions
a
(Sheet 2 of 4)
Description
The Firmware Objects accessed on the PAL Extended User mode
have more specific items selectable than at the User Level.
Tolerances or ranges such as Maximum Penetration can be defined
and limited for the user so that this value cannot be exceeded.
The valves and valve drives connected and controlled by an AUX
interface are listed in this Object class.
The valves controlled by serial communication (serial valves or
multiposition valves) are in the PAL Firmware Object class Serial
Valves.
Items such as Motor Drive, Minimum Speed, and Maximum
Speed are selectable for the Agitator Object. You can set the range
for the speed. The other items are available directly as Method
parameters.
The Firmware Objects accessed in the PAL Extended User mode
have more specific items selectable than at the User Level.
Tolerances or ranges such as Maximum Fill Speed can be defined
and limited for the user so that this value cannot be exceeded.
Items such as Prime Volume, Waste to, Motor Drives, or Scale
Length are specific items that remain hidden at the User Level.
The object class Tools is used to handle another device, such as the
MHE-Tool (Multiple Headspace Extraction Tool) or
MALDI Tool.
The various positions used with the PAL System are selectable at
this level. Positions such as Home, Change Syringe, or a Path
Point, reference the Paths for a specified tray holder directly, such
as Agitator or Stack.
Selecting an item (for example, Home) enables the F1 function
key and displays Check Pos on the screen. Activating this function
provides the possibility of verifying x, y-, z-axes values for this
particular position.
A
Reference Information
Accela Open Autosampler Hardware Manual
Special Functions
125