Control-Xt Board - Thermo Scientific Accela Open Autosampler Hardware Manual

Table 36. DLW-2 option spare parts ordering information (Sheet 2 of 2)
Part name/number
00950-01-00361
00950-01-00362

Control-xt Board

Thermo Scientific
Description
PAL DLW-2 Needle Holder Kit
PAL DLW-2 Actuator Control PCB
Kit, incl. cable and screw set
PN: 00950-01-00329
 To install the control-xt board
Note The Control-xt board replaces the control board (PN CH-952589). This board is
required for the Accela Open Autosampler system and operates only at PAL Firmware
level 4.1.x or later.
1. Follow the sequence shown in
its position inside the x axis. As shown, remove the dummy cover first.
2. Carefully pull the two ribbon cable connectors upwards to free them from the board.
3. Install the replacement board in the reverse order.
Tip After reconnecting the two ribbon cables to the board, ensure that the cables are
folded flat and can slide inside the x axis without damage.
Illustration
Figure 62 to detach and release the Control-xt board from
Accela Open Autosampler Hardware Manual
7
Replaceable Parts
Control-xt Board
109