Specifications - Thermo Scientific Accela Open Autosampler Hardware Manual

1
Introduction

Specifications

Specifications
Table 2. Accela Open Autosampler specifications (Sheet 1 of 3)
Component
Sample capacity
Thermostatted sample tray
Syringe sizes
Liquid injection range
Replicate injections
Minimum sample volume
LC injector
6 Accela Open Autosampler Hardware Manual
Table 2 lists the specifications for the Accela Open Autosampler.
Specification
• Six trays with 54 positions for 2 mL vials
• Six deepwell or standard microtiter-plates with 96 positions
• Six microtiter-plates with 384 positions
• Six trays with 15 positions for 10 mL vials
• 4 to +40 °C in 0.1 °C increments Peltier element
• Temperature cooling: The specification for the stack cooler DW temperature
cooling is defined as:
– TΔ = ≥14.0 °C within 60 minutes
– TΔ = TRoomtemperature – TStack Cooler DW
You must reach a temperature of 14.0 °C between room temperature (22 ±2 °C) and
the stack cooler DW within 60 minutes.
The control unit and the resulting temperature display on the stack cooler DW
(display) are determinative; no comparison to an independent temperature
measurement device is necessary.
• 10, 25, 50, 100, 250, 500, 1000, 2500, and 5000 μL
• Standard DLW syringe: 100 μL
• 10–100 μL with standard 100 μL syringe
• Down to 0.1 μL with solvent sandwich technique
• Down to 0.5 μL with optional 4-port internal loop valve
• Up to 5000 μL with optional larger syringe and loop
• 1–99 from one vial
• 1 μL from a 3 μL sample in 1 mL tapered micro vial
• Electrically actuated fast switching valve drive
• 6-port Injection valve
• VICI™/Valco™ Cheminert™ (P/N 00950-01-00336)
Standard valve and other valves are available upon request.
Thermo Scientific