Electrical Connections - Thermo Scientific Accela Open Autosampler Hardware Manual

2
Installing the Accela Open Autosampler
Installing the Autosampler and DLW

Electrical Connections

Electrical Connections for Single Injection Valve Setup
36 Accela Open Autosampler Hardware Manual
This section contains information on setting up the electrical connections of the Accela Open
Autosampler.
CAUTION Always power off the Open Autosampler before connecting or disconnecting
the DLW cable or any other accessory cables.
The electrical connection of the DLW option is identical for the PAL HTS-xt and the
HTC-xt models. Both models use the same board.
The diagram in Figure 30
interface. If you use a serial or multiposition valve drive, see the diagrams for 2- or 4-injection
valve combinations (Figure
Figure 30. Electrical connection, DLW option on a PAL-xt
shows an installation using the valve drive connected to the AUX
31, and Figure 32 on page 38).
Thermo Scientific