Thermo Scientific Accela Open Autosampler Hardware Manual page 56

2
Installing the Accela Open Autosampler
Installing the Autosampler and DLW
Installing the Power Supply for the Cooled Stack
38 Accela Open Autosampler Hardware Manual
Figure 32. Electrical connections to 4-injection valves, daisy-chaining with PAL-xt system
The power supply for the cooled stack has a built-in control unit with display
(P/N CH-952995).
 To install the power supply
1. Locate the power supply and the AC power cable.
2. Set the power supply switch to OFF.
3. Connect the open end of the DC power cable from the stack/tray cooler to the power
supply connector labeled, Peltier Thermostat.
4. Connect the female end of the AC power cable to the power supply, and then connect the
male end to an AC power outlet.
5. Set the switch on the power supply to ON.
6. Observe the display to ensure that it reads the preset temperature of +10 °C.
Thermo Scientific