Table of Contents
Advertisement
•
For 2D test patterns, the available frame rates are 24, 30, 48, and 60 Frames Per Second
(FPS). The default value is 24 FPS.
•
For 3D test patterns, the available frame rates are 48 and 60 FPS. The default value is 48
FPS.
Changing the frame rate of the display can assist with color measurement when working with
corrected colors.
When changing the frame rate option, the option is applied to the next test pattern you select
unless it is not available for that pattern. If a selected frame rate is not available, the default
frame rate is applied for the test pattern display.
Adjusting the integrator rod and fold mirror
Extreme misalignment of projection optics can cause permanent damage to critical optical
components. Only Christie qualified technicians can perform internal optical adjustments.
Notice. If not avoided, the following could result in property damage.
•
Misalignment of the fold mirror may cause permanent damage to the product.
1. From the Test Pattern menu, select RGB-2K-Integrator Rod.
The test pattern includes guided information for integrator focus and rotation adjustments.
2. Set the projector brightness level to approximately 50% to 60%.
3. Retrieve the 3 mm hex driver located inside the toolbox.
4. Remove the seven screws securing the top cover of the projector and remove it.
5. Loosen the two integrator lock screws.
Cinema 2K-RGB Installation and Setup Guide–CP2415-RGB and CP2420-RGB
020-103259-01 Rev. 1 (10-2022)
Copyright
©
2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Adjusting the image
43
Advertisement
Table of Contents
