Lucent Technologies DEFINITY Installation For Adjuncts And Peripherals page 92

DEFINITY ECS Release 8.2
Installation for Adjuncts and Peripherals 555-233-116
4 Data Modules and Asynchronous Data Units
Connect Data Modules
31. When the SET TM LEAD? prompt appears, press the ENTER/YES
button.
32. Press the NEXT/NO button until the TM = OFF? or TM -> OFF? prompt
appears, then press the ENTER/YES button.
33. When the DONE? prompt appears, press the ENTER/YES button.
34. When the SAVE CHANGES? prompt appears, press the ENTER/YES
button.
The CHANGES SAVED message flashes on screen, and you return to the
HOME screen. The data module is now configured.
Configuring the 8400B Plus Data Module
Figure 17
provides integrated voice and data communications over standard, 2-wire,
twisted-pair circuits within 2000 ft. of a DEFINITY. The unit can emulate a Hayes-
compatible interface for standard personal computer (PC) communication. The
options for the 8400B Plus are set from the rear panel interface. Refer to
DEFINITY Communications System User's Guide for procedures.
SET TM LEAD?
Push the button indicated by the arrow ( )
TM = OFF?
Push the button indicated by the arrow ( )
DONE?
Push the button indicated by the arrow ( )
SAVE CHANGES?
Push the button indicated by the arrow ( )
shows the rear of a 8400B plus asynchronous data module. The unit
NEXT/NO BACK ENTER/YES
DATA
DATA NEXT/NO BACK ENTER/YES
NEXT/NO BACK ENTER/YES
DATA
DATA NEXT/NO BACK ENTER/YES
Issue 1
April 2000
70