Lucent Technologies DEFINITY Installation For Adjuncts And Peripherals page 129

DEFINITY ECS Release 8.2
Installation for Adjuncts and Peripherals 555-233-116
7 DEFINITY LAN Gateway System
Connecting a PC
1. Attach the connector on one end of a modular cord to the modem. Attach
the other connector to the modular wall jack (information outlet).
2. Connect the second modem to the wall jack at the remote terminal site.
3. If you are installing a printer, connect the printer to the terminal, and set
the printer options as described in the printer manual. Then set the
corresponding options on the terminal to match.
4. If you are not installing a printer, set the terminal options according to the
instructions in the terminal documentation.
5. At the terminal, enter AT.
6. If the modem is installed correctly, it responds with OK (on the terminal
screen).
7. Enter ATDT and the telephone number of the modem connected to Port B
(listed on the Installing the Terminals worksheet).
If the terminal is installed correctly and if the DEFINITY LAN Gateway is in
the ADX, OAM, OS or AINIT state, the screen displays the login prompt.
8. If the terminal does not display the login prompt, write down the state
displayed, then see the troubleshooting procedures for terminal
connections in CallVisor ASAI/DEFINITY LAN Gateway documentation.
Connecting an administration PC via
Asynchronous Data Units
Connect as shown in Figure 31.
Issue 1
April 2000
107