Lucent Technologies DEFINITY Installation For Adjuncts And Peripherals page 65

DEFINITY ECS Release 8.2
Installation for Adjuncts and Peripherals 555-233-116
4 Data Modules and Asynchronous Data Units
Connect Data Modules
4. The CONTINUE? prompt appears. Press the ENTER/YES button.
Setting the break-disconnect option on 7400A DCE
This setting specifies the length of the BREAK signal, a string of 10 or more
spaces that tells the host that the user needs to interrupt operations. There are
three options: TRIPLE, LONG (the default), and NONE. Accept the default
values, unless otherwise instructed.
1. When the SET BREAK DISC? prompt appears, press the NEXT/NO
button to keep the default.
Configuring the RS-232 interface on 7400A DCE
You can set each pin of the RS-232 cable to meet the needs of specific
applications or connected equipment. however, in most cases, you can use the
defaults.
To set the EIA leads, proceed as follows:
1. When the SET LeadName LEAD? prompt appears, press the NEXT/NO
button to keep the default or the ENTER/YES button to make a change.
CONTINUE?
Push the button indicated by the arrow ( )
SET BREAK DISC?
Push the button indicated by the arrow ( )
SET LeadName LEAD?
Push the button indicated by the arrow ( )
NEXT/NO BACK ENTER/YES
DATA
DATA NEXT/NO BACK ENTER/YES
DATA NEXT/NO BACK ENTER/YES
Issue 1
April 2000
43