Lucent Technologies DEFINITY Installation For Adjuncts And Peripherals page 107

DEFINITY ECS Release 8.2
Installation for Adjuncts and Peripherals 555-233-116
5 External Modems
Setting Up the PARADYNE COMSPHERE 3910
Exiting the DTE Dialer menu
Skip over the remaining menu headings. Proceed as follows.
1. Press F1 to select Nxt.
The ResultCode Form menu heading appears.
2. Press F1 to select Nxt.
The AT Cmnd Mode menu heading appears.
3. Press F1 to select End.
The Edit StrapGroup > menu heading appears.
Configuring the Data Line
Set the line speed and accept the default values for the other settings. Proceed
as follows.
Opening the dial line menu
1. From the Edit StrapGroup > menu heading, press the right-arrow button
twice.
The Dial_Line menu item appears.
2. Press F1 to select the Dial_Line menu heading.
The Dial Line Rate menu heading appears.
Setting the line rate
1. From the Dial Line Rate menu heading, press the right-arrow button four
times.
The 9600(V32b) menu item appears.
2. Press F2 to select 9600(V32b).
Exiting the dial line menu
Skip over the remaining menu headings. Proceed as follows.
1. Press F1 to select Nxt.
The V32bis Automode (Enable) menu heading appears.
2. Press F1 to select Nxt.
The V32bis Autorate (Enable) menu heading appears.
3. Press F1 to select Nxt.
The Dial Tx Level (Permissv (-9)) menu heading appears.
4. Press F1 to select Nxt.
The V22b Guard Tone (Disable) menu heading appears.
Issue 1
April 2000
85