Call Detail Recording Option Settings; Connecting Cdr Equipment To Definity; Using A Printer As The Cdr Output Device - Lucent Technologies DEFINITY Installation For Adjuncts And Peripherals

DEFINITY ECS Release 8.2
Installation for Adjuncts and Peripherals 555-233-116
13

Call Detail Recording Option Settings

Connecting CDR Equipment to DEFINITY

Call Detail Recording Option
Settings
This chapter provides information on connecting Call Detail Recording (CDR)
equipment to a DEFINITY.
Connecting CDR Equipment to
DEFINITY
The interface between the DEFINITY and CDR equipment may be a
Data module (see
Units'', for recommended settings)
Modem (see
documentation for recommended settings)
TN726 data line circuit pack and an asynchronous data unit
CDR equipment can connect directly to the DCE connector (EIA Port) on the rear
of the control carrier in all systems except R8csi. Data modules or modems are
not required. In R8csi, CDR equipment connects to the MODEM (P2) connector
on the processor interface cable.
Using a Printer as the CDR Output
Device
You can use a printer can an output-receiving device for CDR. The
recommended option settings for the AT&T Model 572 printer are shown in
25.
Chapter 4, ''Data Modules and Asynchronous Data
Chapter 5, ''External
13
Modems'', and the modem vendor's
Issue 1
April 2000
145
Table