Lucent Technologies DEFINITY Installation For Adjuncts And Peripherals page 103

DEFINITY ECS Release 8.2
Installation for Adjuncts and Peripherals 555-233-116
5 External Modems
Setting Up the PARADYNE COMSPHERE 3910
3. Press the F1 button to select Factory.
The Ld Fact Preset: > prompt appears.
4. Press the right-arrow button.
5. Press F2 to select Async_Dial.
6. Press F3 to select Save.
The Sav EditArea to > prompt appears.
7. Press F1 to save configuration changes to the Active(Saved) storage
area.
Since you are changing the active area to a new set of options— Factory/
Async_Dial—the modem automatically runs a power-on self-test. The
Idle:19.2 and Status Configure messages appear.
8. To return to the top-level menu at any time, press the double up-arrow
button.
Loading the copied default settings
Load the default settings so that you can edit them for use with CMS. Proceed as
follows.
1. On the front panel of the COMSPHERE 3910, press F2 to select
Configure.
The Ld EditArea frm > prompt appears.
2. Press the right-arrow button once.
The Active(Saved) prompt appears.
3. Press F1 to select Choose Function.
4. Press F1 to select Edit.
The Edit StrapGroup > prompt appears.
Configuring the DTE interface
Set the data speed and enable standard, RS-232 communications settings.
Proceed as follows.
Configuring basic, RS-232 handshaking
Start by selecting values for the basic parameters of serial data communications,
mode, speed/rate, framing, and error correction (parity). The modem uses these
parameters when it negotiates a connection with another RS-232 device, a
process called handshaking.
1. From the Edit StrapGroup > prompt, press F1 to select DTE_Interface.
The Async/Sync Mode menu heading appears.
Issue 1
April 2000
81