Lucent Technologies DEFINITY Installation For Adjuncts And Peripherals page 68

DEFINITY ECS Release 8.2
Installation for Adjuncts and Peripherals 555-233-116
4 Data Modules and Asynchronous Data Units
Connect Data Modules
Enabling test mode on 7400A DCE
The test-mode (pin 25) setting can have either of two values: ON or OFF (the
default).
1. Accept the default values, unless otherwise instructed. When the SET TM
LEAD? prompt appears, press the NEXT/NO button to keep the default,
ON.
Exiting menus and saving changes on 7400A DCE
1. When the DONE? prompt appears, press the ENTER/YES button.
2. When the SAVE CHANGES? prompt appears, press the ENTER/YES
button.
Your changes are saved.
SET TM LEAD?
Push the button indicated by the arrow ( )
DONE?
Push the button indicated by the arrow ( )
SAVE CHANGES?
Push the button indicated by the arrow ( )
CHANGES SAVED
Push the button indicated by the arrow ( )
DATA NEXT/NO BACK ENTER/YES
DATA NEXT/NO BACK ENTER/YES
DATA NEXT/NO BACK ENTER/YES
DATA NEXT/NO BACK ENTER/YES
Issue 1
April 2000
46