Control Valve-Governor Screen-Governor Pipes; Oil Filter - Oil Pan; Modulator - Modulator Valve - Jeep 1979 CJ-5 Technical & Service Manual

2C-78 AUTOMATIC TRANSMISSION
Fig. 2C-160 iear Serve Cover and Gasket installation
Coitrol Valve-Governor Screen-Governor Pipes
(1) Insert governor pipes into valve body and install
governor screen in case.
NOTE: Be sure the governor screen is in position be-
fore installing the control valve and governor pipes. The
open end of the screen must face the interior of the
transmission case.
(2) Install control valve and governor pipes (fig. 2C-
161).
NOTE: Be sure the manual valve is properly indexed
with the manual detent lever pin and be sure the gover-
nor pipes are properly installed in the case.
(3) Install control valve attaching bolts, and manual
detent and roller assembly.
(4) Tighten detent solenoid and control valve at-
taching bolts to 10 foot-pounds (14 N*m) torque.
Fig. 2C-161 Control Valve Installation
Oil Filter-Oil Pan
(1) Install case-to-intake pipe O-ring seal on intake
pipe.
(2) Install replacement filter on intake pipe. Install
filter on end of intake pipe marked "filter."
(3) Install assembled filter and intake pipe and in-
stall filter-to-control valve retainer bolt (fig. 2C-162).
CAUTION: The oil filter must be replaced after any
major repair.
(4) Position oil pan gasket on case.
(5) Position oil pan on case and install oil pan bolts.
Tighten oil pan bolts to 13 foot-pounds (18 N®m) torque.
Fig. 2C-162 Oil Filter and Intake Pipe Installation
Modulator-Moditator Valve
(1) Insert modulator valve into case bore with stem
end of valve facing outward.
(2) Install modulator adapter and adapter retainer
on case. Tighten attaching bolt to 18 foot-pounds (24
N*m) torque (fig. 2C-163).
(3) Install O-ring seal on modulator and install
modulator in adapter.
(4) Install modulator retainer and modulator-to-
adapter attaching bolt. Tighten bolt to 18 foot-pounds
(24 N*m) torque (fig. 2C-9).
Governor
(1) Insert governor assembly into transmission case
and mesh driven gear of governor with drive gear in case
(fig. 2C-164).
(2) Install gasket on governor cover and install
cover on transmission case. Tighten cover bolts to 18
foot-pounds (24 N®m) torque.