Discharge Shield (No Conditioner); Removing Shield (No Conditioner) - MacDon R113 Unloading And Assembly Instructions
Rotary disc 13-foot self-propelled windrower header
Hide thumbs
Also See for R113:
- Operator's manual (294 pages) ,
- Assembly instruction manual (212 pages) ,
- Unloading and assembly instructions (166 pages)
Table of Contents
Advertisement
8.4 Discharge Shield (No Conditioner)
8.4.1 Removing Shield (No Conditioner)
Follow these steps to remove the shielding installed on a rotary header configured without a conditioner:
1. Raise the mower fully and extend the center-link to
maximize the space between the shield (A) and the
carrier frame (B).
2. Remove four M16 hex head bolts (A), nuts, and flat
washers securing the shield (B) to the panel on
mower (C).
3. Lift the shield (A) until pins (B) disengage from slots in
support (C) and shield on panel (D).
214075
CHANGING THE CONDITIONER
Figure 8.28: Header Side View
Figure 8.29: Header Side View
80
Revision A
Advertisement
Table of Contents
