Discharge Shield - No Conditioner; Removing Discharge Shield - No Conditioner - MacDon R113 Unloading And Assembly Instructions

4.3 Discharge Shield – No Conditioner
Discharge shields control the distribution of unconditioned crop when no conditioner is installed.
• If a conditioner is being installed, the discharge shield needs to be removed. For instructions, refer to
Discharge Shield – No Conditioner, page
• If a conditioner is being removed, the discharge shield needs to be installed. For instructions, refer to
Discharge Shield – No Conditioner, page
4.3.1 Removing Discharge Shield – No Conditioner
Discharge shields may need to be removed for machine service, but a rotary disc header without a conditioner should NOT
be operated without the discharge shield.
1. On both ends of the header, remove four M16 hex head
bolts, nuts, and flat washers (A) securing shield (B) to
header panel (C).
2. Lift shield (A) until pins (B) (one on each side) disengage
from the slots in support (C).
262300
CHANGING CONDITIONER
33.
34.
Figure 4.34: Left Side of Header – Right Opposite
Figure 4.35: Left Side of Header – Right Opposite
33
4.3.1 Removing
4.3.2 Installing
A
A
C
B
C
B
A
Revision A