5 Operation
Result
5.7 Performing ECG monitoring
Requirement
90
EN
MEDUCORE Standard
In the curve view: Evaluate the SpO
the measured values for arterial oxygen saturation (SpO
pulse rate (Pulse).
5. If necessary: Make the following SpO
menu
(see "7.3.3 SpO
•
Adapt the feed speed of the plethysmogram
•
Give the pulse tone output priority over the heart rate tone
output so that the tone pitch is output depending on
oxygen saturation, even when the ECG cable or pad
electrodes are connected to the patient.
6. If necessary: Set alarm limits in the user menu
Alarm settings", page
or
Set automatic alarm limits in the application menu
Application menu", page
7. If necessary: Deactivate the pulse tone with the heart rate tone/
pulse tone function button.
8. If there are artifacts in the SpO
not sufficient (bar in the SpO
pulse oximetry sensor on the patient's limb.
Pulse oximetry monitoring is performed.
•
The device is switched on
page
76).
•
A patient group is selected
group", page
78).
•
An ECG cable and the ECG electrodes are connected
Connecting the ECG cable and ECG electrodes", page
1. If necessary: Select another patient group
the patient group", page
2. If necessary: Select the monitor mode by pressing the Monitor
function button.
2
curve (Pleth) and read off
2
settings in the user
2
settings", page
114):
2
111).
106).
curve or if the signal quality is
2
parameter field): Reposition the
2
(see "5.1 Switching the device on",
(see "5.4 Selecting the patient
78).
) and
2
(see "7.3.1
(see "6
(see "4.6
64).
(see "5.4 Selecting