Weinmann MEDUCORE Standard2 Instructions For Use Manual page 74

4 Preparation
Result
4.8.2 Removing the SD card
Requirement
74 EN MEDUCORE Standard
2. Push the SD card into the SD card slot until it clicks into place.
When doing so, please note: The beveled corner of the SD card
must be at the front on the right during insertion.
3. Close the water jet protection to protect the device from the
ingress of dust and water.
The SD card is inserted in the device and ready for use.
After the device is switched on, the symbol
display.
An SD card is in the SD card slot.
1. Open the water jet protection of the SD card slot.
Incorrect use may result in loss of data!
If you remove the SD card while the symbol
during an ongoing session, data may be lost or the SD card
damaged.
⇒ Only remove the SD card if the device is switched off or the
following symbols
2. Briefly press in the SD card.
The SD card is ejected slightly.
3. Remove SD card.
4. Close the water jet protection to protect the device from the
ingress of dust and water.
2
or are displayed.
appears on the
is displayed or