Buttons On Device Setting - Omron K6CM User Manual

6 How to Use the Software Tool
6-1-4

Buttons on Device Setting

This section describes the following setting screen tool buttons in the upper left part of the device set-
ting screen.
Settings screen
tool button
Buttons and tooltips
Motor information
Add device
Delete device
Device network set-
ting
Monitoring setting
Save file
Read file
Downloading
(PC→device)
Uploading
(Device→PC)
Device Reset
6 - 18
Outline of operation
Displays the screen to input motor information.
Display a screen to add a device to the currently open project.
Set the motor name, device type, IP address with the same value
as already set for the actual device.
Note : The IP address of the K6CM device cannot be set from
here.
Delete the selected device.
Display the screen to change the IP address of the device.
Motor group name and device type can not be changed and dis-
played.
Displays the setting screen for the monitoring cycle. Set the cycle
for reading the measured value of the K6CM device.
Save the setting values displayed in the software tool.
If implemented during monitoring, priority will be given over moni-
toring.
Therefore, there is a possibility that the monitoring may be delayed
or the save may fail due to an error.
If implemented during monitoring, priority will be given over moni-
toring.
Therefore, monitoring may be delayed or failed due to an error.
Writes the setting values displayed in the software tool to the tar-
get device.
If implemented during monitoring, priority will be given over moni-
toring.
As a result, monitoring may be delayed or failed due to communi-
cation error.
Reads the setting values of the target device to the software tool.
If implemented during monitoring, priority will be given over moni-
toring.
As a result, monitoring may be delayed or failed due to communi-
cation error.
Perform a device reset (restart the device) for the target device.
It is used to validate the setting after changing the setting value.
K6CM Motor Condition Monitoring Device User's Manual (N219)
Device
reset button
Enable / disabled condition
Selectable during monitoring
execution (grayed out)
Selectable during monitoring
execution (grayed out)
Selectable during monitoring
execution (grayed out)
Selectable during monitoring
execution (grayed out)
Selectable during monitoring
execution (grayed out)
----
----
----
----
----