Tool Button And Software Reset Button On Device Setting Screen - Omron K6CM User Manual

5-3-5

Tool Button and Software Reset Button on Device Setting Screen

This section describes the following setting screen tool buttons in the upper left part of the device set-
ting screen.
Settings screen
tool button
Buttons and tooltips
Motor information
Add device
Delete device
Sysmac Gateway
Console
Option setting
Save file
Read file
Downloading
(PC→device)
Uploading
(Device→PC)
Software reset But-
ton
K6CM Motor Condition Monitoring Device User's Manual (N219)
5 Setting with the Motor condition monitoring Tool
Outline of operation
Displays the screen to input motor information.
Display a screen to add a device to the currently open project.
Set the motor name, device type, IP address with the same value
as already set for the actual device.
Note : The IP address to the actual device can not be set from
here.
Delete the selected device.
Display the screen to change the IP address of the device.
Motor group name and device type can not be changed and dis-
played.
Display the screen for setting options.
"Monitoring cycle" setting: Sets whether or not monitoring is to be
performed for the device.
Save the value displayed on the computer to a file.
If implemented during monitoring, priority will be given over moni-
toring.
Therefore, there is a possibility that the monitoring may be delayed
or the save may fail due to an error.
The data of the file is read out and displayed on the computer.
If implemented during monitoring, priority will be given over moni-
toring.
Therefore, monitoring may be delayed or failed due to an error.
Download the value displayed on the PC to the target device.
If implemented during monitoring, priority will be given over moni-
toring.
As a result, monitoring may be delayed or failed due to communi-
cation error.
Upload the parameters of the target device to the computer.
If implemented during monitoring, priority will be given over moni-
toring.
As a result, monitoring may be delayed or failed due to communi-
cation error.
Perform a soft reset (restart the device) for the target device.
It is used to validate the setting after changing the setting value.
Software
reset button
Enable / disabled condition
Selectable during monitoring
execution (grayed out)
Selectable during monitoring
execution (grayed out)
Selectable during monitoring
execution (grayed out)
Selectable during monitoring
execution (grayed out)
Selectable during monitoring
execution (grayed out)
----
----
----
----
----
5 - 31
5