Omron K6CM User Manual page 40

2 Nomenclature and Functions
Status of Alarm Bar, Status Indication, and Transistor Output for
Each Status
Status
Measurement and monitoring are not
Measuring and monitoring
completed until the measured value
Not yet
is set after the power is turned ON.
Compre- All measurement values are in nor-
hensive mal condition.
alarm: nor-
mal
Compre- There is no "Critical" in the measure-
During mea-
hensive ment value, and even one of them
suring and
alarm: has "Warning".
monitoring
Warning
Compre- There is "Critical" in at least one
hensive measurement value.
alarm: Criti-
cal
After measuring When using the trigger function
and monitoring (external trigger or internal trigger),
(only when using the trig- the measuring and monitoring is
ger function) completed.
Self-diagnosis error is occurring
When the self-diagnosis
regardless of measuring and moni-
error occurs
toring status.
When the power is OFF
*1. This is the case when the transistor output type is set to Normally Closed. In the case of Normally Open, ON/OFF is op-
posite to the above.
2 - 8
Description Alarm bar
Not lit.
Green
Yellow
Red
The sta-
tus at the
end is
kept.
Not lit.
----
Not lit.
K6CM Motor Condition Monitoring Device User's Manual (N219)
Status dis- Transistor Transistor
play output 1 output 2
Not lit. OFF
"MON"
*1
ON
*1
OFF
*1
OFF OFF
Not lit. The status The status
at the end is at the end is
kept.
"ERR" OFF
Not lit. OFF
Transistor
output 3
OFF OFF
ON
*1
ON
ON
*1
ON
ON
*1
ON
kept.
OFF OFF
OFF OFF