Omron K6CM User Manual page 97

4
Select [[K6CM] Create the project].
The following confirmation screen will be displayed.
Precautions for Correct Use
Be sure to select [Device setting] before selecting [[K6CM] Create the project].
If [[K6CM] Create the project] is selected before selecting [Device setting], proceed to Step 6
and click the [Cancel] Button to close the screen. Click the [Cancel] Button and do not save the
project, please exit. Then start the Motor condition monitoring Tool again.
5
Click the [OK] Button.
The following [Select Connection Method] Dialog Box is displayed.
• [Auto connection] Button:
Note 1. Directly connect the computer and devices cone-on-one, and then click it.
2. If the IP address setting method of the K6CM device is set to BOOTP, auto connection can
• [Fixed IP Connection] Button: Used to connect to the device with specifying the IP address of
Note The Fixed IP connection Button can be used to connect devices when multiple devices are con-
nected via a hub. However, do not connect devices with the same IP address. IP address may
become duplicated and communications may fail.
6
Click the [Auto connection] Button.
The [Preface] wizard screen of the following [Start navigation] Dialog Box is displayed.
K6CM Motor Condition Monitoring Device User's Manual (N219)
Used to connect to the device without specifying the IP address
of the connected device.
not be made until connecting to the BOOTP server.
the connected device.
4 Introduction of the Software Tool
4
4 - 31