Tag Data Link Connection Setting Procedures; A-9-1 Using The Cs/Cj-Series; Using The Cs/Cj-Series - Omron K6CM User Manual

Appendices
A-9 Tag Data Link Connection Setting
Procedures
A-9-1

Using the CS/CJ-series

You can set tag data link settings using the Network Configurator for EtherNet/IP.
When using the CS/CJ-series PLC as an originator, use the Network Configurator for EtherNet/IP
supporting the model and version of the CPU Unit. Refer to the CS/CJ Series EtherNet/IP Units
Operation Manual (Cat. No.W465) for the setting status of the setting tool.
The setting method when the CS/CJ-series PLC is an originator is as follows.
1
Starting the Network Configurator for EtherNet/IP
To start the Network configurator, select [All Programs] | [OMRON] | [Sysmac Studio] | [Network
Configurator for EtherNetIP] | [ Network Configurator] from the Windows Start Menu.
The Main Window consists of a Hardware List and a Network Configuration Pane, as shown in
the following diagram.
A - 24
K6CM Motor Condition Monitoring Device User's Manual (N219)