Omron K6CM User Manual page 72

4 Introduction of the Software Tool
Log file example
The display example of the log file concerning the degradation level with the comprehensive current
diagnosis type is shown below.
When the monitoring cycle setting of the software tool is set to 86,400 seconds (= 1 day) ...
Data is saved
every day.
The degradation level (current value) exceeded the degradation level alarm (Warning) and an alarm
was output. The K6CM status and the degradation level status have changed according to those states.
For the K6CM status and the individual measurement and monitoring status, refer to the table below.
K6CM status
Bit posi-
tion
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
4 - 6
The alarm values which
are set in the K6CM device
are displayed.
Status
Measurement CPU error
Measurement CPU data flash error
Main CPU error
Main CPU data flash error
Reserved.
Reserved.
Reserved.
Reserved.
Running Time status
Monitoring condition
Reserved.
Reserved.
Trigger input (ON/OFF state of the exter-
nal trigger input)
TR 1 (transistor 1output state)
TR 2 (transistor 2output state)
TR 3 (transistor 3output state)
The status changes depending
on the status of input/output and
measured values.
If the motor degrades
Bit contents
0
Not occurred
Not occurred
Not occurred
Not occurred
Unreached
Measurement and
monitoring
stopped
OFF
OFF
OFF
OFF
K6CM Motor Condition Monitoring Device User's Manual (N219)
1
Occurrence
Occurrence
Occurrence
Occurrence
Reached
During measure-
ment and monitor-
ing
ON
ON
ON
ON