Omron K6CM User Manual page 100

4 Introduction of the Software Tool
Insulation resistance
type
11
If you do not want to set the parameters, click the [Skip] Button.
The [Download to device] wizard screen of the following [Start navigation] Dialog Box is dis-
played.
Note 1. If you click the [Skip] Button, the parameters will not be downloaded.
If you set the parameters, click the [Next] Button. The [Download to device] wizard screen of the
following [Start navigation] Dialog Box is displayed.
2. If you click the [Next] Button, the parameters will be downloaded.
4 - 34
Model Parameter name
Applicable circuits
Using inverter
Inverter special
measurement
Setting value
Input the set value according to the motor drive method.
0: Three-phase three-wire S-phase ground
1: Three-phase four-wire N-phase ground, load side
delta connection
Input the set value according to the presence or
absence of the inverter.
0: Without inverter
1: With inverter
Input the set value according to the inverter frequency
0: Set when inverter frequency is far from commer-
cial frequency
1: Set when inverter frequency is close to commer-
cial frequency
K6CM Motor Condition Monitoring Device User's Manual (N219)