Omron K6CM User Manual page 244

Appendices
Device name in hard-
CS1W-EIP21
CJ1W-EIP21?CJ2?*1
*1.This shows the case where the CJ1W-EIP21 Unit is mounted on the CJ2 CPU Unit.
(2) Device Node Address (IP Address) Setting
Set the node address (IP address) of the device to be used.
In the Network Configuration Window, click the device you want to change the node
address (IP address), right click and select [Change Node Address (A) ...].
Enter the node address (IP address) of the device to be used actually, and click [OK].
5
EtherNet/IP Connection Settings
(1) Create Tag sets and Tags
Create tag sets and those members tags necessary for connection for the registered Etehr-
Net/IP Unit. For tags, you can set the I/O memory address or network symbols used by the
control program (CJ2H-CPU6□-EIP21 and CJ2M-CPU3□ only).
Additional Information
The setting contents depend on the originator device connecting the K6CM series.
For detailed settings, refer to the manual of the originator device.
• "SYSMAC CS/CJ Series EtherNet/IP Units Operation Manual (Cat. No.W465)"
Additional Information
Tag set names and tag names can also be created in advance using the CX-Programmer.
When creating in advance, make them the same names as the tags to be created with the Net-
workConfiguratior. You can also use them as symbol variables of PLC by sharing them with
CX-Programmer by importing from or exporting to a file the tag set names and tag names of
PLC edited with Network Configurator.
For detailed settings, refer to the manual of the originator.
(1)-1 Tag Editing
Select the device (e.g., CJ1W-EIP21) for editing the tag set and the tag.
Then right-click it and select [Parameter (P)] | [Edit (E) ...] or double-click it.
A - 28
Unit version
ware list
Unit version.1.0
Unit version.2.0 and 2.1
Unit version.3.0
Unit version.2.0 and 2.1
Unit version.3.0
Major revi-
sion
1
2
3
2
3
K6CM Motor Condition Monitoring Device User's Manual (N219)
CIP revision
Revision name in hardware
list
Rev1
Rev2
Rev3
Rev2
Rev3