Omron K6CM User Manual page 176

8 Monitoring and Setting Using the EtherNet/IP Devices
• Using the CS/CJ-series
For detailed information on the Network Configurator, refer to the following manual.
CS/CJ Series EtherNet/IP Units Operation Manual (Cat. No.W465)
1
Install and start
(1) Install Network Configurator.
(2) Start Network Configurator.
(3) Download the K6CM EDS file from our I-Web and install it on the Network Configurator.
Register the CIP revision corresponding to the EIP version on the side label of the
K6CM device.
2
Configuration
(1) Register PLC and K6CM devices in the network configuration and set the IP address.
(2) Configure settings to add a connection between devices (Make a connection).
Note Things to check beforehand:
8 - 6
EIP version
Major revision
Ver. 1.0 1
Ver. 1.1 2
K6CM-CIMA-EIP
MOTOR CONDITION MONITORING
CURRENT INFORMATION MONITOR
MSIP-
REM-
OMR-
K6CM01
Open-type
Measuring Equipment.
(01)04549734178693
(21)XXXXXXXXXX
MAC ADDRESS : YYYYYYYYYYYY
URL: http://www.aso.omron.co.jp/download/
Kyoto, 600-8530, JAPAN
MADE IN JAPAN
• Which memory area (I/O memory or variables) in the PLC should be used for the
tag data link.
• The size of the internal data (parameter) of the K6CM is 44 bytes for all models.
2)-1 Drag a K6CM to the PLC and register it.
2)-2 Click the [Edit Tag Sets] Button to create input tags with the above sizes.
2)-3 Register the input tag as it is as input tag set.
2)-4 Select the input tag set created in 2) -3 above from the pull-down list.
2)-5 Register the connection.
CIP revision
Revision on the Hardware list
Rev 1
Rev 2
MAIN : Ver.1.0
EIP : Ver.1.1
MES : Ver.1.0
MAIN : Ver.1.0
EIP : Ver.1.1
MES : Ver.1.0
See Manual
K6CM Motor Condition Monitoring Device User's Manual (N219)