Omron K6CM User Manual page 35

Nomenclature and Functions of the Front Panel of the K6CM Device
Push-In Plus terminals (*1)
LCD display for numerical value
such as measured value
Status
display
Product status
indication
Network status
indication
EtherNet/IP port
Name
Alarm bar display The LED bar emits light according to the state
of the comprehensive alarm (above the mea-
surement value).
Unit of measurement The unit of the measurement value (monitor-
value (monitoring cate- ing category) is indicated by the following
gory) LCD characters.
Press the [DISP] key to switch the display.
K6CM Motor Condition Monitoring Device User's Manual (N219)
2 Nomenclature and Functions
DIN Track hook
Push-In Plus terminals (*1)
Alarm bar display
Unit of measurement value
(monitoring category) (*2)
Types of measurement such
as current value, minimum value,
and maximum value
[ARM RST] Key
[DISP] Key
Push-In Plus terminals (*1)
*1. Refer to "Push-In Plus terminals
layout" described below.
*2. Unit of measurement value
(monitoring category)
· Vibration and temperature type
mm/s
G
· Insulation resistance type
MΩ
· Comprehensive current diagnosis type
Cim
Meaning
During measuring and monitoring, the following colors are
used.
• Comprehensive alarm (normal): green
• Comprehensive alarm (Warning): Yellow
• Comprehensive alarm (Critical): Red
Note : The above LCD color is retained after measuring and
monitoring.
Turns OFF when one of the following occurs:
when the power is OFF, when measuring and monitoring is
not started yet, when self-diagnos error occurs.
• "G": Acceleration, "mm/s": Velocity, "T": Motor temperature
"∆T": Temperature gap (Difference from room temperature
to room temperature) (Vibration & temperature type)
• "MΩ": Insulation resistance, "mA": Leakage current (Insula-
tion resistance type)
• "A": Current, "Cim": Degradation level (Comprehensive cur-
rent diagnostic type)
Front operating part
T T
mA
A
2 - 3
2