Omron K6CM User Manual page 59

Precautions for Correct Use
In the upper limit alarm, if Critical threshold
threshold
performed when only the value exists. It is as follows.
Numeric LCD display
Transistor Output 1
(At the Normally
closed * 2)
Transistor Output 2
(At the Normally
closed * 2)
The above is an example in which the alarm latch is disabled and the trigger mode is Always
(without trigger), but in other cases the threshold of Warning is ignored.
K6CM Motor Condition Monitoring Device User's Manual (N219)
Warning threshold, Warning threshold is ignored and Critical threshold operation is
≥
Measured value
Critical level
Warning level
Power ON
(*1)
Alarm bar Green
Measured value displayed
Status display
ON
OFF
ON
OFF
*1. In the above figure, the power-ON state and the unmeasured state (i.e., the state
until the measured value is calculated) that exist immediately after turning ON the
power as shown on page 3-7 are omitted.
*2. The transistor output type of output 1 and output 2 can also be set to "Normally
Open". In the case of Normally Open, ON/OFF is opposite to the above.
3 Measuring and Monitoring Mechanism
Warning threshold, lower critical alarm, Critical
≤
it is the same operation as when
Warning level does not exist.
Red Green
"MON"
Time
3 - 15
3