Omron K6CM User Manual page 50

3 Measuring and Monitoring Mechanism
Detailed information on trigger mode and behavior by status
The operation of the K6CM device, trigger mode and state, and the operation results from the Motor
condition monitoring Tool and EtherNet/IP are as follows.
Trigger
Status
mode
Always While the power is
ON
External Measuring and
trigger monitoring Not yet
During measuring
Or
and monitoring
Internal trig-
ger
After measuring
and monitoring
*1. The measuring and monitoring status can be confirmed by "K6CM status" from EtherNet/IP.
Example of Operation When the Trigger Mode Is "Always"
Measured value
Power ON
(*1)
Numeric LCD display
Status display
3 - 6
Measuring and
Front Numeric LCD Dis-
monitoring sta-
*1
tus
Measurement and Either the present value,
monitoring the minimum value, or the
maximum value of the
measurement value
No measuring and "- - - -" is displayed
monitoring
Measurement and Either the present value,
monitoring the minimum value, or the
maximum value of the
measurement value
No measuring and Holding and displaying
monitoring values at the end of mea-
suring and monitoring
Measurement and monitoring period
Measuring and monitoring
During measuring and monitoring
Either the current value, the minimum value,
or the maximum value of the measured value
"MON"
*1.In the above figure, the power-ON state and the unmeasured state (i.e., the state until
the measured value is calculated) that exist immediately after turning ON the power
as shown below are omitted.
K6CM device Operation
Status dis-
play play
"MON"
Not lit.
"MON"
Not lit.
Power ON the next time
Either the current value,
or the maximum value
of the measured value
K6CM Motor Condition Monitoring Device User's Manual (N219)
Motor condition monitoring Tool
and read value with the Ether-
Net/IP
The present value, the minimum
value, and the maximum value of
the measurement value can be read
out individually
The read value is 0
The present value, the minimum
value, and the maximum value of
the measurement value can be read
out individually
The held values are read out at the
end of the measuring and monitor-
ing
Time
Measuring
and monitoring
During measuring
and monitoring
the minimum value,
"MON"