Functions And Specifications Of The Software Tool - Omron K6CM User Manual

Current Value Display and Automatic Logging and History Display
Current value display and automatic logging of the following data of the K6CM device are possible.
* The project is saved along with the log file.
Target data
• Measured value
• Alarm result
Measurement
value, alarm result
Read at specified
4-1-2

Functions and Specifications of the Software Tool

Item
Project
Logging
1 Number that can
be registered in
the project
Graph display
Files to create
*1. If logging is continued at short measurement intervals, the amount of log data may increase and the memory
capacity of the PC may run short. If a warning message indicating insufficient memory capacity appears, move
the log file to a different location and reopen the project file.
K6CM Motor Condition Monitoring Device User's Manual (N219)
Current value display
Display current value at spec-
ified cycle
Software tool
Current value
Automatic
Logging
At the end of the project
CSV files (referred to as
"log file")
* The software tool obtains the clock information from the PC.
Therefore, do not change the time setting of the PC during
logging and between the logging interruption and the logging restart.
Motor condition monitoring equipment
K6CM device
Number of files that can be created
Supported format
Measurement interval
Number of motors
Number of devices per motor
Device type per motor
Types of graphs
Display period
4 Introduction of the Software Tool
Automatic logging / history display
• Automatic logging at the same designated cycle as the left, history
display possible
• At the end of project Save to CSV file called "log file" (For details,
refer to "Log file" of Details of the file to be created on page 4-4.)
Current
value
No limit
CSV data format
5 to 9999 seconds*1
10
3
Only one type is possible.
The same device type cannot be registered in the same
motor name.
Polygonal line
1 hour, 1 day, 1 month, 3 months, 6 months, 1 year, 2 year,
5 year, 10 year, 20 year
The following is created in the folder of the project file name.
• Project file (binary format)
• Parameter file (binary format)
• Log file (CSV format)
For details, refer to Details of the file to be created on the
next page.
Specifications
4
4 - 3