Omron K6CM User Manual page 104

Motor condition, monitoring device
Hide thumbs Also See for K6CM:
Table of Contents

Advertisement

4 Introduction of the Software Tool
When confirming the IP address of the registered device
If you want to check the IP address of the device registered on the project, perform the following opera-
tions.
1
Select the device you want to change and click the
screen tool button.
The following [K6CM configuration setting] Dialog Box is displayed.
Note The IP address displayed here is the value registered in the project.
When changing the IP address of the device
When changing the IP address of the device
1
Select the device you want to change and click the
screen tool button.
The following [K6CM configuration setting] Dialog Box is displayed.
2
Change the IP address. Change the subnet mask and default gateway as necessary.
3
Click the [OK] Button.
The IP address setting on the project is changed, and at the same time, the IP address of the
actual device at the communication destination is automatically changed.
4 - 38
[Device setting] Button on the setting
[Device setting] Button on the setting
K6CM Motor Condition Monitoring Device User's Manual (N219)

Advertisement

Table of Contents
loading

Table of Contents