Motor Monitoring Using Software Tools; Monitoring Procedure With Motor Condition Monitoring Tool; Set The Monitoring Cycle - Omron K6CM User Manual

7-3 Motor Monitoring Using Software
Tools
This section describes how to monitor a motor using the software tools.
7-3-1

Monitoring Procedure with Motor Condition Monitoring Tool

It depends on the following procedure.
1
Click the
2
In the upper right corner of the screen, select [Monitoring by motor category] or [Monitoring by
monitoring category] from the pulldown list.
3
Monitoring is performed on the [Monitoring by motor category] screen or [Monitoring by monitor-
ing category] screen.
Precautions for Correct Use
In order to monitor the K6CM with the software tool, the communications service of the SYS-
MAC Gateway communication driver between the computer and the K6CM must be in the start
status.
The status of SYSMAC Gateway's communication service can be checked on the SYSMAC
Gateway Console screen.
The SYSMAC Gateway Console screen is activated by clicking [Device setting] on the startup
screen or by clicking the [SYSMAC Gateway Console] Button on the monitoring screen.
7-3-2

Set the Monitoring Cycle

Click the [Monitoring setting] Button.
Set Monitoring cycle on the following screen.
The settable range is 5 to 99999 seconds. The default value is 600 seconds (10 minutes).
K6CM Motor Condition Monitoring Device User's Manual (N219)
7 Motor Monitoring with the K6CM Devices and the Software Tool
[Monitoring setting] Button and set "Monitoring cycle".
7
7 - 9