A-7 Setting Values - Omron K6CM User Manual

A-7 Setting Values

In this section, the setting values in the internal data of the K6CM devices are classified according to
K6CM common and monitor type, and are shown in a list.
Precautions for Correct Use
In order to validate the setting value, it is necessary to turn the power supply ON again or per-
form a soft reset after changing the set value.
The alarm threshold settings are performed by integer values (e.g., 0 to 9999) regardless of the
measurement range. Therefore, confirm the measurement range and units in the table shown
below, and then set the alarm threshold.
Alarm Setting Values (threshold value)
Vibration & temperature Type (K6CM-VBM)
Data name
Acceleration, High alarm threshold
(Critical and Warning)
Velocity, High alarm threshold (Critical
and Warning)
Motor temperature, High alarm
threshold (Critical and Warning)
Temperature Gap, High alarm thresh-
old (Critical and Warning)
Insulation Resistance Type (K6CM-ISM)
Data name
Insulation resistance, Low alarm
threshold (Critical and Warning)
Comprehensive Current Diagnosis Type (K6CM-CIM)
Data name
Degradation level, High alarm
threshold (Critical and Warning)
Current, High alarm threshold
(Critical and Warning)
K6CM Motor Condition Monitoring Device User's Manual (N219)
Description
0 to 9999
(unit: 0.01 G)
0 to 9999
(unit: 0.01 mm/s)
0 to 9999 (unit: °C)
0 to 9999 (unit: °C)
Description
0 to 9999
(Unit: 0.001 MΩ)
Description
0 to 999
0 to 9999
Unit:
Current range = 0: 0.01 A
Current range = 1 to 5: 0.1 A
Writing method (Yes: supported, No: supported)
CIP message
Software tool
communications
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Writing method (Yes: supported, No: supported)
CIP message
Software tool
communications
Yes Yes
Writing method (Yes: supported, No: supported)
CIP message
Software tool
communications
Yes
Yes
Appendices
Tag data link
No
No
No
No
Tag data link
No
Tag data link
Yes No
Yes No
A - 15
A