Omron K6CM User Manual page 61

When [ALM RST] Key Is Pressed After Measuring and Monitoring
When using the trigger function (i.e., external trigger or internal trigger), if you press the [ALM RST]
key after measuring and monitoring, the alarm bar turns green and the transistor output turns on.
Warning level
Numeric LCD display
Status display
Transistor Output 1
(At the Normally
closed * 2)
Transistor Output 2
(At the Normally
closed * 2)
K6CM Motor Condition Monitoring Device User's Manual (N219)
Measured value
Critical level
Power ON
Measuring and
(*1)
monitoring Not yet
Alarm bar
No lit.
"- - - -"
No lit.
ON
OFF
ON
OFF
*1. In the above figure, the power-ON state and the unmeasured state (i.e., the state
until the measured value is calculated) that exist immediately after turning ON the
power as shown on page 3-7 are omitted.
*2. The transistor output type of output 1 and output 2 can also be set to "Normally
Open". In the case of Normally Open, ON/OFF is opposite to the above.
3 Measuring and Monitoring Mechanism
Start measuring and monitoring
Green Yellow Red
Remains red
Measured value displayed
"MON"
Remains OFF
Remains OFF
Time
End measuring and monitoring
After measuring
and monitoring
Green
Measured value displayed
at the end of measurement
No lit.
(ON)
(ON)
[ALM RST] key is pressed
3
3 - 17